Features
– Input for DC current signal
– Build-in pluggable cross connector
– Measure by Hall effect transducer
– Isolated power supply source for passive loads on output
– Voltage or current output configurable by DIP-switches
– Galvanic isolation at 2000 Vac
– Good accuracy and performance stability
– EMC compliant – CE mark
– DIN rail mounting in compliance with EN-50022 and EN-50035
General Description
The converter DAT 5023Idc is designed to convert the DC current signal from 0÷5 A to 0÷60 A applied on its input in a voltage or current output signal.
The device is available in three versions (A, B and D) in function of the input current value ( refer to “Technical specification” section).
The user can program the output ranges by the proper DIP-switches available after opening the suitable door located on the side of device (see “Output ranges table” sections).
The regulation of Zero and Span values is made by the ZERO and SPAN potentiometers located on the top of device.
The 2000 Vac isolation between power supply and output eliminates the effects of all ground loops eventually existing and allows the use of the converter in heavy environmental conditions found in industrial applications.
The measure of the input signal is executed by a cross connector and a Hall effect transducer; this allows to isolate the input side from the output and power supply. The DAT 5023Idc provides on the output side an auxiliary supply source to connect both active and passive loads.
It is housed in a plastic enclosure of 27.5 mm thickness suitable for DIN rail mounting in according to EN-50022 and EN-50035 standards .